Table 7-2 Alphabetical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 213 Message Description Action DETECTABLE SIZE IN TRAY XX For help press alternates with DETECTABLE SIZE IN TRAY XX Recommend move switch to STANDARD A tray has been loaded with paper that is a standard size and the switch in the tray is set to custom. 1 Press for detailed information. 2 Press and to step through instructions. DISK DEVICE FAILURE alternates with Ready For menus press A device failure has occurred on the specified drive. 1 Printing may continue for jobs that do not require access to the disk drive. 2 To clear the message, turn the printer off and then back on.
3 If the message persists, remove and re-install the EIO disk drive. 4 If the message persists, replace the EIO disk drive. DISK FILE OPERATION FAILED alternates with Ready For menus press The printer received a PJL file system command that attempted to perform an illogical operation (for example, to download a file to a non-existent directory). 1 Printing may continue. 2 Turn the printer off and then back on. 3 If the message reappears, there may be a problem with the software application.
DISK FILE SYSTEM IS FULL alternates with Ready For menus press The printer received a PJL file system command that attempted to store something on the file system but was unsuccessful because the file system is full. 1 Use the HP Web Jetadmin software to delete files from the EIO disk drive and try again. 2 To remove this message from the display, turn the printer off and then back on. DISK IS WRITE PROTECTED alternates with Ready For menus press The file system device is protected and no new files can be written to it. 1 To enable writing to the disk, turn off write protection, using HP Web Jetadmin. 2 To remove this message from the display, turn the printer off and then back on.
EIO DISK X NOT FUNCTIONAL For help press The EIO disk in slot X is not working correctly. Remove the EIO disk from the slot indicated and replace with a new EIO disk drive. FLASH DEVICE FAILURE alternates with Ready For menus press A device failure has occurred on the specified drive. 1 Printing may continue for jobs that do not require the Flash DIMM. 2 To remove this message from the display, turn the printer off and then back on. 3 If the message persists, remove and re-install the Flash DIMM. 4 If the message persists, replace the Flash DIMM.