Table 7-2 Alphabetical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 219 Message Description Action RAM DISK FILE OPERATION FAILED alternates with Ready For menus press The printer received a PJL file system command that attempted to perform an illogical operation (for example, to download a file to a non-existent directory). 1 Printing may continue. 2 Turn the printer off and then back on to remove the message from the display. 3 If the message reappears, there may be a problem with the software application.
RAM DISK FILE SYSTEM IS FULL alternates with Ready For menus press The printer received a PJL file system command that attempted to store something on the file system but was unsuccessful because the file system is full. Turn the printer off and then back on to remove the message from the display. This will also delete any files saved in RAM. RAM DISK IS WRITE PROTECTED alternates with Ready For menus press The file system device is protected and no new files can be written to it. 1 To enable writing to the RAM disk, turn off write protection using HP Web Jetadmin software. 2 To remove this message from the display, turn the printer off and then back on.
Receiving upgrade A firmware upgrade is in progress. Do not turn the printer off until the printer returns to Ready. REINSTALL CARTRIDGE alternates with For help press The cartridge is not fully seated. 1 Press for detailed information. 2 Press and to step through instructions. REMOVE ALL PRINT CARTRIDGES To exit press Cancel Job key The printer is executing a Component test and the component selected is Belt only. Remove all print cartridges. REMOVE AT LEAST 1 PRINT CARTRIDGE To exit press Cancel Job key The printer is executing a Disable cartridge check or Component test where the component selected is Cartridge Motor. Remove one print cartridge.
REPLACE CARTRIDGE alternates with For help press The identified print cartridge has reached the end of life. Printing will not continue until the cartridge is replaced. 1 Replace the identified print cartridge to continue printing. 2 Press for detailed information. 3 Press and to step through instructions. 4 Supplies ordering information is also available from the embedded Web server. REPLACE FUSER KIT The fuser kit is at end of life. 1 Replace the fuser to continue printing. 2 Press for detailed information. 3 Press and to step through instructions. 4 Supplies ordering information is also available from the embedded Web server.