Table 7-3 Numerical printer messages (continued) 226 Printer error troubleshooting C9660-90901 Message Description Action 13.XX.YY.JAM IN TRAY 3 For help press A page is jammed in Tray 3. 1 Press for detailed information about clearing the jam. 2 Press and to step through the instructions. 3 Clean the pickup roller. If it is worn or damaged, replace it. 4 Clean the feed roller. If it is worn or damaged, replace it. 5 Replace the Tray 3 pickup solenoid. 6 Replace the Tray 3 pickup motor. 7 Replace the Tray 3 paper feeder PCB. 8 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.
20 INSUFFICIENT MEMORY For help press alternates with 20 INSUFFICIENT MEMORY To continue press The printer has received more data from the computer than fits in available memory. 1 Press to resume printing. Note: A loss of data will occur. 2 Reduce the complexity of the print job to avoid this error. 3 Adding memory to the printer may allow printing of more complex pages. 22 EIO X BUFFER OVERFLOW To continue press The printer’s EIO card in slot X has overflowed its I/O buffer during a busy state. Press to resume printing. Note: A loss of data will occur.
22 PARALLEL I/O BUFFER OVERFLOW For help press alternates with 22 PARALLEL I/O BUFFER OVERFLOW To continue press The printer’s parallel buffer has overflowed during a busy state. Press to resume printing. Note: A loss of data will occur. 22 SERIAL I/O BUFFER OVERFLOW To continue press The printer’s serial buffer has overflowed during a busy state. Press to resume printing. Note: A loss of data will occur. 40 BAD SERIAL TRANSMISSION To continue press A serial data error (parity, framing, or line overrun) has occurred while the printer was receiving data. Press to resume printing. Note: A loss of data will occur.
40 EIO X BAD TRANSMISSION To continue press A connection with the card in EIO slot X has been abnormally broken. 1 Press to resume printing. Note: A loss of data will occur. 2 Check that all cables are connected to the EIO ports and that the EIO board is seated properly. 3 If possible, print to another network printer to verify the network is working properly.