Table 7-3 Numerical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 225 Message Description Action 13.XX.YY JAM IN TOP COVER AREA For help press There is a jam in the top cover area. 1 Press for detailed information about clearing the jam. 2 Press and to step through the instructions. WARNING! The fuser might be hot. 3 Check that the fuser paper sensor is in place. If it is defective, replace it. 4 Replace the fuser. 5 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 13.XX.YY.JAM IN TRAY 1 For help press A page is jammed in the multi-purpose tray.
1 Press for detailed information about clearing the jam. 2 Press and to step through the instructions. 3 Clean the pickup roller. If it is worn or damaged, replace it. 4 Clean or replace the separation pad. 5 Replace the Tray 1 pickup solenoid. 6 Replace the pickup motor. 7 Replace the paper pickup assembly. 8 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 13.XX.YY.JAM IN TRAY 2 For help press A page is jammed in Tray 2. 1 Press for detailed information about clearing the jam. 2 Press and to step through the instructions. 3 Clean the pickup roller. If it is worn or damaged, replace it. 4 Clean the feed roller.
If it is worn or damaged, replace it. 5 Replace the Tray 2 pickup solenoid. 6 Replace the pickup motor. 7 Replace the paper pickup assembly. 8 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.