Table 7-3 Numerical printer messages (continued) 224 Printer error troubleshooting C9660-90901 Message Description Action 13.XX.YY.JAM IN DUPLEX PATH For help press There is a jam in the duplex path. 1 Press for detailed information about clearing the jam. 2 Press and to step through the instructions. 3 Check if the ETB rollers or gears are worn or defective. Replace the ETB if they are. 4 Check the duplex feed guide, which is part of the control panel crossmember assembly. If the guide is worn or damaged, replace the crossmember assembly. 13.XX.YY.JAM IN PAPER INPUT PATH For help press There is a jam in the media input path. 1 Press for detailed information about clearing the jam.
2 Press and to step through the instructions. 3 Check the registration shutter, and make sure it is in place. Replace the paper pickup assembly if the shutter is damaged. 4 Check the paper pickup feed rollers, and replace them if they are worn or damaged. 5 Check the connectors, gears, solenoids, motors, and PCB on the paper pickup assembly. Replace the paper pickup assembly if necessary. 13.XX.YY JAM IN PAPER PATH For help press There is a jam in the media path. 1 Press for detailed information about clearing the jam. 2 Press and to step through the instructions.
3 If paper is folding into an accordion shape, check whether the shutter on each print cartridge opens as you close the ETB and if each cartridge is turning properly. Replace defective print cartridges or drive motors. 4 Clean the attaching roller at the bottom of the ETB and make sure the spring is holding it in place. 5 If the attaching roller gears are defective, replace the ETB. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294. 6 Replace the paper pickup PCB. 7 Replace the ETB if it is not moving paper properly. Calibrate the printer. 8 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.