HP — Numerical printer messages

Numerical printer messages Note Many of the procedures in this section instruct you to replace the DC controller PCB, the ETB, the formatter, the drum drive motors, the drum drive gears, or a laser/scanner unit. After replacing one of these items, you must access the Print Quality menu and select CALIBRATE NOW to ensure proper print quality after the repair. See “Calibrate Now” on page 294 for instructions on calibrating the printer. When the ETB or the fuser are replaced before their normal end of life, access the Resets menu and reset the counter to zero. See page 81 and page 83 for instructions.

Table 7-3 Numerical printer messages C9660-90901 Chapter 7 Troubleshooting 223 Message Description Action 10.XX.YY SUPPLIES ERROR For help press NOTE: The printer cannot always determine whether the error lies with the cartridge or with the printer reader/writer. The printer cannot read or write to at least one print cartridge memory tag or at least one memory tag is missing. XX Description 00 memory error on supply item 10 memory tag missing YY Description 00 black print cartridge 01 cyan print cartridge 02 magenta print cartridge 03 yellow print cartridge 1 Turn the printer off and then back on.

2 Swap the cartridge for the color indicated with a cartridge in another slot to determine whether the error follows the cartridge or stays with the slot. If the error follows the cartridge, replace that cartridge. Otherwise, continue with step 3. 3 Reseat the connectors between the memory PCB (J602-J605) and the antenna PCBs (J901A-D), the memory PCB, and the DC controller PCB (J1028). 4 Replace the antenna PCB. 5 Replace the memory PCB. 6 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.

13.XX.YY.DUPLEX JOB INTERRUPTED For help press alternates with 13.XX.YY.DUPLEX JOB INTERRUPTED Discard top sheet and press or 13.XX.YY.DUPLEX JOB INTERRUPTED Discard top two sheets and press A duplex job was interrupted by interference as media passed through the output bin during duplexing. 1 Press for more information. 2 Remove one or two pages from the output bin as directed by the display. 3 Press to continue printing. NOTE: If JAM RECOVERY = OFF some pages will not be reprinted. Re-send the missing pages.