HP — Numerical printer messages

Table 7-3 Numerical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 229 Message Description Action 50.X FUSER ERROR For help press A fuser error has occurred. X Description 1 low fuser temperature 2 fuser warmup service 3 high fuser temperature 4 faulty fuser 5 inconsistent fuser 6 open fuser 1 Turn the printer off and allow it to cool down. 2 Reinstall the fuser, and check the connector J4034 that connects the fuser and the printer. Replace the connector if it is damaged. 3 Turn the printer off and remove the fuser. Measure the resistance between the connector pins on the fuser. If resistance does not meet the following guidelines, replace the fuser. J4034-5 to J4034-6:

300 - 500 KOhms J4034-1 to J4034-2: less than 1 KOhm 4 Check for continuity between connector pins J4034-4 and J4034-2. If there is no continuity, replace the fuser. 5 Replace the fuser power supply PCB. 6 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 51.XY PRINTER ERROR For help press alternates with 51.XY PRINTER ERROR To continue turn off then on A printer error has occurred. X Description 1 beam detect error 2 laser error Y Description 0 no color K black C cyan M magenta Y yellow 1 Press to continue. 2 Turn the printer off and then back on.

3 Reseat the connectors between the laser/scanner and DC controller PCB (J1009 - J1012). 4 Replace the defective laser/scanner assembly. Calibrate the printer after replacing the laser/scanner. See “Calibrate Now” on page 294. 5 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 52.XY PRINTER ERROR For help press alternates with 52.XY PRINTER ERROR To continue turn off then on A printer error has occurred. X Description 1 scanner error 2 scanner startup error 3 scanner rotation error Y Description 0 no color K black C cyan M magenta Y yellow 1 Press to continue. 2 Turn the printer off and then back on.

3 Reseat the connectors between the laser/scanner and DC controller PCB (J1009 - J1012). 4 Replace the defective laser/scanner assembly. Calibrate the printer after replacing the laser/scanner. See “Calibrate Now” on page 294. 5 Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. 53.X0.ZZ PRINTER ERROR To continue turn off then on An error has occurred in the onboard RAM. 1 Press to continue. 2 Turn the printer off and then back on.