Table 7-3 Numerical printer messages (continued) C9660-90901 Chapter 7 Troubleshooting 233 Message Description Action 64 PRINTER ERROR For help press alternates with 64 PRINTER ERROR To continue turn off then on Scan buffer error. 1 Turn the printer off and then back on. 2 Perform a cold reset. See “Cold reset” on page 293 for instructions. 3 If the message persists, replace the formatter or firmware DIMM. 68.X PERMANENT STORAGE ERROR For help press alternates with 68.X PERMANENT STORAGE ERROR To continue press One or more printer settings saved in the non-volatile storage device is invalid and has been reset to its factory default. Pressing the button should clear the message.
Printing can continue, but there may be unexpected behavior. X Description 0 onboard NVRAM 1 removable disk (flash or hard) 1 Press to continue. 2 Turn the printer off and then back on. 3 Check the printer settings to determine which settings have been changed. 68.X PERMANENT STORAGE FULL For help press alternates with 68.X PERMANENT STORAGE FULL To continue press A non-volatile storage device is full. Pressing the button should clear the message. Printing can continue, but there may be unexpected behavior. X Description 0 onboard NVRAM 1 removable disk (flash or hard) 1 Press to continue. 2 For 68.0 errors, turn the printer off and then back on.
3 If a 68.0 error persists, execute an NVRAM inititialization. See “NVRAM initialization” on page 293. 4 For 68.1 errors, use the HP Web Jetadmin software to delete files from the disk drive. 5 If a 68.1 errors persists, reinitialize the hard disk. See “Hard disk initialization” on page 294. 68.X PERMANENT STORAGE WRITE FAIL To continue press A non-volatile storage device is failing to write. Pressing the button should clear the message. Printing can continue, but there may be unexpected behavior. X Description 0 onboard NVRAM 1 removable disk (flash or hard) 1 Press to continue. 2 Turn the printer off and then back on. 3 If the problem persists, initialize NVRAM.
See “NVRAM initialization” on page 293. 4 Reinitialize the hard disk. See “Hard disk initialization” on page 294. 79.XXXX PRINTER ERROR To continue turn off then on A critical hardware error has occurred. 1 Turn the printer off and then back on. 2 If the problem persists, reseat the firmware DIMM. 3 Reseat the formatter. 4 Replace the firmware DIMM. 5 Replace the formatter. Calibrate the priner. See “Calibrate Now” on page 294. 8X.YYYY EIO ERROR The EIO accessory card in slot X has encountered a critical error. 1 Turn the printer off and then back on. 2 If the problem persists, reseat the EIO card. 3 Replace the EIO card.