Jams in the paper path Table 7-9 Causes for jams in the paper path 242 Paper path troubleshooting C9660-90901 Cause Solution Registration shutter is defective. (This applies to jams that occur before the registration roller.) Make sure the shutter is clean, moves smoothly, and that the spring is in place. If the shutter is damaged, replace the paper pickup assembly. Drive gears are damaged. (This applies to jams that occur before the registration roller.) Check the drive gears in the paper pickup unit. Replace the pickup drive assembly if the gears are damaged. Registration roller and registration sub roller are dirty, worn, or damaged.
(This applies to jams that occur before the registration roller.) Clean the registration roller or registration sub roller if it is dirty. If it is still dirty after cleaning, or if it is worn or damaged, replace the paper pickup assembly. Attaching roller is damaged. (This applies to jams in which paper is crumpled into an accordion as it enters the ETB.) Check if the attaching roller is damaged. If it is damaged, replace the ETB. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294. Cartridge shutter open/close mechanism is damaged.
(This applies to jams in which paper is crumpled into an accordion fold somewhere on the ETB belt.) The shutters in each print cartridge should open as you close the ETB. If a shutter does not open, replace that print cartridge. Also check for a damaged shutter mechanism in the printer. Cartridge drive motor assembly is damaged. Inspect the cartridge drive assembly in each print cartridge. If any are damaged, replace the assembly for that print cartridge. Attaching roller is defective. Make sure the attaching roller is clean and the spring is in place. If the roller is damaged, replace the ETB. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294.
Paper leading edge sensor is defective. Replace the pickup PCB. DC controller PCB is defective. Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294.