Jams in the top cover Table 7-10 Causes for jams in the top cover Jams in the duplex path Table 7-11 Causes for jams in the duplex path C9660-90901 Chapter 7 Troubleshooting 243 Cause Solution Fuser paper sensor or sensor lever is defective. Make sure the fuser paper sensor lever moves smoothly and is set in place. Replace the lever if it is damaged. Replace the sensor if it is defective. Fuser sleeve or pressure roller does not rotate smoothly. If the fuser drive gears are worn or damaged, replace the fuser. Fuser inlet guide is dirty or has built-up toner. Clean the fuser inlet guide. Fuser sleeve or pressure roller is dirty, worn, or damaged. Clean the fuser sleeve or pressure roller.
If it is damaged, replace the fuser. Fuser delivery sensor or sensor lever is defective. Make sure the fuser delivery sensor lever moves smoothly and is set in place. Replace the lever if it is damaged. Replace the sensor if it is defective. Fuser delivery roller is worn. Replace the fuser. Fuser delivery roller drive gears are worn or damaged. Replace the fuser. Face-down delivery roller is defective. Replace the fuser. DC controller PCB is defective. Replace the DC controller PCB. Calibrate the printer after replacing the DC controller. See “Calibrate Now” on page 294. Cause Solution Oblique rollers are worn or damaged. Replace the oblique rollers.
Oblique roller drive gears are worn or damaged. Replace the ETB unit. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294. Duplex feed guide is damaged. Replace the ETB unit. Calibrate the printer after replacing the ETB. See “Calibrate Now” on page 294.