HP — Paper is wrinkled or folded

Paper transport troubleshooting If media is feeding incorrectly, use the information in this section to identify and resolve the problem. Multiple pages are fed Table 7-12 Causes for multiple pages feeding Paper is wrinkled or folded To diagnose the cause of wrinkled or folded paper, use the Print/Stop test in the Diagnostics menu. Adjust the stop time so the paper stops before it enters the fuser. Open the ETB. If paper is wrinkled at this stage, use Table 7-14 to diagnose the problem. If paper is not wrinkled at this stage, use Table 7-13 to diagnose the problem. See page 291 for more information on the Print/Stop test.

Table 7-13 Causes for wrinkled or folded paper (part one, paper path entrance) Table 7-14 Causes for wrinkled or folded paper (part two, paper path exit) 244 Paper transport troubleshooting C9660-90901 Cause Solution Separation tabs in the cassette are damaged (Tray 2 or Tray 3). Straighten the tabs on the front corners of the tray, or replace the cassette. Multi-purpose tray separation pad is worn. Replace the separation pad assembly. Multi-purpose tray separation pad has a defective spring. Make sure the spring is set in place. If the spring is damaged, replace the separation pad assembly. Cause Solution Registration shutter is defective.

Make sure the registration shutter is clean and moves smoothly. If the registration shutter is worn or damaged, replace the paper pickup assembly. Feed roller or registration roller is dirty or defective. Replace the paper pickup assembly. Paper path has foreign substances or dirt. Remove any foreign substances or dirt from the paper path. If the feed guide is damaged, replace the paper pickup assembly. Cartridge shutter open/close mechanism is damaged. (This applies to jams in which paper is crumpled into an accordion fold somewhere on the ETB belt.) The shutters in each print cartridge should open as you close the ETB. If a shutter does not open, replace that print cartridge.

Also check for a damaged shutter mechanism in the printer. Cause Solution Fuser inlet guide is dirty. Clean the fuser inlet guide. Fuser pressure roller is dirty or damaged. Clean the pressure roller. If the pressure roller is damaged, replace the fuser. Fuser sleeve is dirty or damaged. Clean the fuser sleeve. If the fuser sleeve is damaged, replace the fuser. Fuser delivery roller is dirty. Clean the fuser delivery roller.