HP — Repetitive defects troubleshooting

Repetitive defects troubleshooting Defects on printer rollers can cause image defects to appear at regular intervals on the page. Use the repetitive defects ruler on the next page (Figure 7-3) to measure the distance between defects that recur on a page. Use Table 7-36 to determine which roller is causing the defect. To resolve the problem, try cleaning the roller first. If the roller is still dirty after cleaning or if it is damaged, replace the indicated part. Note Letter codes before the roller names in Table 7-36 correspond to the letters at the top of the repetitive defects ruler in Figure 7-3. Not all rollers are shown in the ruler. CAUTION Do not use solvents or oils to clean rollers.

Instead, rub the roller with lint-free paper. If dirt is difficult to remove, rub the roller with lint-free paper dampened with rubbing alcohol. Table 7-36 Repetitive defect spacing Note Defects on the cassette pickup roller or the multi-purpose tray pickup roller do not cause a repetitive defect. Defects on these rollers cause a defect to appear only on the leading edge of the image.

260 Repetitive defects troubleshooting C9660-90901 Roller Distance Type of defect Replacement part A toner charging roller 14 mm print cartridge B developing cylinder 33 mm defect on front of paper print cartridge C primary charging roller 38 mm blank spots print cartridge D toner feed roller 39 mm print cartridge E media attaching roller 38 mm defect on front of paper ETB F fuser pressure roller 63 mm poor fusing fuser G photosensitive drum or transfer rollers (center-to-center distance) 75 mm Replace any print cartridges that have a damaged photosensitive drum. Replace the ETB.

H photosensitive drum 94 mm defect on front of paper blank spots print cartridge J fuser sleeve 107 mm poor fusing fuser cassette feed roller 54 mm defect on front of paper cassette cassette feed sub roller 44 mm defect on back of paper cassette registration roller 54 mm defect on back of paper paper pickup assembly registration sub roller 57 mm defect on front of paper paper pickup assembly fuser delivery roller 38 mm defect on back of paper fuser face-down delivery roller 49 mm defect on back of paper fuser cassette pickup roller see note below defect on front of paper paper pickup rollers multi-purpose tray pickup roller see note below defect on back of paper MP tray pickup roller assembly