HP — Individual diagnostic tests

Individual diagnostic tests The following sections explain in more detail how to operate the various diagnostics properly. Print event log This item prints an event log that displays the last 50 entries in the printer’s event log, starting with the most recent. Show event log This item displays on the control panel the last 50 events on the control panel display, starting with the most recent. PQ troubleshooting This item prints a series of print quality assessment pages that help troubleshoot print quality problems.

Disable cartridge check (special mode test) This diagnostic test allows you to print internal pages or send an external job to the printer with one or more print cartridges removed or swapped. Because the cartridges are not keyed, the diagnostic test can be run with one to four cartridges removed or swapped to another location. Consumable supply errors are ignored while in this mode. Once in this mode, you can navigate the menus and print internal pages or send an external print job to the printer. This diagnostic test can be used to isolate print quality problems related to individual cartridges and to isolate individual cartridge problems such as noise.

Note Do not remove or swap cartridges before entering the disable cartridge check diagnostic. After entering the test, you can remove or swap cartridges. While performing the disable cartridge check, you can navigate the menus and print internal pages as desired from the control panel. Use the button to access the menus as you normally would. You can also send external print jobs to the printer. To exit this diagnostic, press the C ANCEL J OB button and then select Exit diagnostics . Paper path test This diagnostic will generate one or more test pages that you can use to isolate the cause of paper jams.

To isolate a problem, you can specify which input tray to use, specify whether to use the duplex path, and specify the number of copies to print. Multiple copies can be printed to help isolate intermittent problems. The following options become available after you enter the diagnostic: G Print test page . Run the paper path test from the default settings: Tray 2, no duplex, and one copy. To specify other settings, scroll down the menu and select the setting, then scroll back up and select PRINT TEST PAGE to execute the test. G Source . Select Tray 1, Tray 2, or Tray 3 (if the optional 500-sheet paper feeder is installed). G Duplex . Enable or disable 2-sided printing. G Copies .

Set the numbers of copies to be printed; the choices are 1,10, 50, 100, or 500. C9660-90901 Chapter 7 Troubleshooting 287