HP — Individual diagnostic tests

Print/Stop test This diagnostic test can be used to isolate the cause of problems, such as image formation defects and jams, within the engine. This test allows you to stop the paper anywhere along the printer's paper path. The test can be programmed to stop printing internal pages or an external print job when the paper reaches a certain position. The test can also be programmed to stop from 0 to 60,000 mS. If the timer is set to a value that is greater than it takes to print the job, there are two ways to recover the printer. G After the print job completes, press C ANCEL J OB to return to the diagnostic menu before the timer times out. G After the timer times out, press C ANCEL J OB .

You will have to cycle the door switch to restart the engine and return it to a normal state. When the timer trips, the display shows the message Printing stopped, Press to continue . Pressing will print the previously selected job. If you do not want the previous job to print, press C ANCEL J OB first, and then press the button. Note Do not attempt to execute a Print/Stop test while the printer is calibrating; a power cycle will be required. If you encounter a jam message during testing, cycle the door switch. C9660-90901 Chapter 7 Troubleshooting 291