The following component tests can be executed: G Transfer motors . This test turns the components involved in the image transfer process: the cartridge motors, the ETB motor and belt (if the ETB is closed and the connector is seated), and the print cartridges (if the ETB is closed). You can remove or install print cartridges during this test. G Belt only . This test turns only the ETB motor and belt. The ETB must be closed and the connector seated. The display prompts you to remove the cartridges because the ETB belt contacts the photosensitive drums and cannot turn without them rotating also. Rotating the photosensitive drums could damage the belt or photosensitive drums.
If covers are removed, you must manually cycle the door switch after removing the cartridges for the test to execute. G Cartridge motors . This test rotates only the print cartridge drive motors. The display prompts you to remove at least one cartridge for the same reason as stated for the Belt only test. The engine rotates the cartridge motor(s) for only the cartridges that are removed. To rotate all motors sequentially, remove all cartridges; to isolate one motor, remove only that cartridge. If covers are removed, you must manually cycle the door switch after removing the cartridges for the test to execute.
Always start this test with all cartridges installed, and cycle the door switch so the printer recognizes the configuration. Then proceed with the test, removing one or more cartridges. G Black, Magenta, Yellow, Cyan laser/scanners . These four tests allow you to rotate each scanner motor individually. G Fuser motor . This test rotates the fuser motor and drive gears. G Alienation motor (also called the developing disengaging motor). This test moves the developing disengaging rod, clutches, and plates through their three positions: • Clean/Home: middle position; all cartridges disengaged; used during cleaning cycle • Color:
top position; no cartridges disengaged; used during color printing • Black: lowest position; C, M, and Y cartridges disengaged, black engaged; used during black-only printing G Tray1/Tray 2 solenoids . This test activates and releases the Tray 1 and Tray 2 solenoids. The Tray 1 solenoid is the lower solenoid. Tray 2 is the upper solenoid. You can remove the two securing screws and rotate the paper pickup unit to get a better view of the solenoids. 290 Diagnostics C9660-90901