To toggle a sensor, find and move the sensor flags in the following locations: G A . Remove Tray 2. The flag is located in the center paper inlet path of the paper pickup unit, directly in front of right-side white roller. The flag is recessed above the registration shutter in the paper pickup unit. WARNING! The fuser might be hot; wait 10 minutes for it to cool down. G B . Open the ETB and wait for the fuser to cool down. The fuser inlet flag is in located at the front center of the fuser. Access the flag from above the black print cartridge. G C . The fuser delivery flag is located at the upper center of fuser, behind the fuser Caution label. It is wrapped in a clear roller. G D .
The output bin full sensor is located on upper rear edge of the fuser. G E . Remove Tray 2. The Tray 1 (MP tray) paper presence sensor flag is the black lever on the front right of the paper tray cavity. G F . Remove Tray 2. The Tray 2 paper presence sensor flag is the black lever in the middle center of the paper tray cavity. G G . Remove Tray 2. The Tray 2 paper size sensor switches are located on the left rear side of the paper tray cavity. G H . The door switch is located on the right front of the printer frame (underneath the right cover). Component test (special mode test) The component test allows you to exercise individual parts independently to isolate problems.
Each component test can be exercised once or repeatedly. If CONTINUOUS is selected as the repeat option, the test will cycle the component on and off. This process will repeat for 2 minutes, and then the test will terminate. Menus cannot be accessed during component tests, so the button serves the same function as the C ANCEL J OB button. Note The door interlock switch must be defeated to run any of the component tests. If covers are removed, the door switch must be manually cycled during some tests for the engine to recognize a change. The ETB assembly can be open, closed, or removed while some of these tests are executing. Print cartridges can be installed or removed during certain tests.
The display prompts for removal of some or all cartridges during certain tests in order to rotate and isolate certain components, as well as to protect the cartridges and ETB. C9660-90901 Chapter 7 Troubleshooting 289