HP — Calibrate Now

Hard disk initialization A hard disk initialization will erase and reformat the printer’s hard disk. Perform hard disk initialization only if an error code appears on the control panel indicating an EIO disk error. Always try initializing the hard disk before replacing it. To initialize the hard disk 1 Turn the printer on. 2 As the printer performs its power-on sequence, press and hold the P AUSE /R ESUME button until all three lights on the control panel are lit. 3 Press . The display should show INITIALIZE DISK . 4 Press . The printer will initialize the hard disk and continue its power-on sequence.

Calibration bypass During certain diagnostic procedures, you will need to bypass the automatic calibration that is performed whenever the printer is turned on. To bypass calibration 1 Turn the printer on and watch the control panel display. 2 When the display begins showing the memory count, press and hold until all three lights on the control panel are lit. 3 Press . 4 Press P AUSE /R ESUME . The display should show SKIP DISK LOAD . 5 Press until SKIP CALIBRATION is highlighted. 6 Press . The printer will skip calibration and then continue its power-on sequence.

Calibrate Now Use the following procedure to calibrate the printer whenever you replace the DC controller, the ETB, the drum drive motors, the drum drive gears, or a laser/scanner. 1 Press to enter the MENUS . 2 Press to highlight CONFIGURE DEVICE . 3 Press to select CONFIGURE DEVICE . 4 Press to highlight PRINT QUALITY . 5 Press to select PRINT QUALITY . 6 Press to highlight CALIBRATE NOW . 7 Press to select CALIBRATE NOW . 8 Wait for the printer to calibrate. 294 Engine resets C9660-90901