HP — Replacing the transfer unit

Replacing the transfer unit Replace the transfer unit when the printer control panel displays: REPLACE TRANSFER KIT . Note If you replace the transfer unit when it is not at the end of life, for instance if it is defective, you will need to calibrate the printer and reset the transfer unit count through the control panel. See page 81 for instructions. 1 Turn the printer off. 2 Using the side handles, open the top cover. 3 Grasp the green handle on the transfer unit and pull down. The front cover will open as you pull down the transfer unit. 4 Locate the blue release buttons on either side of the transfer unit (near the bottom of the transfer unit). 5 Grasp the transfer unit with two hands.

Simultaneously press in the blue buttons on either side of the transfer unit and slide the unit out of the printer. C9660-90901 Chapter 4 Printer maintenance 79