LVS-7500 External System Installation and Quick Start Guide Step 1: Installation Checklist The LVS-7500 External System and accompanying parts arrive in a cardboard shipping box. Carefully open the shipping box and locate each part within the foam support compartment. A list of each part is located below. Refer to the next section for a picture of each part. If any item is missing or damaged, contact your Omron Microscan representative for assistance.
LVS-7500 External System installation flash drive (includes LVS-7500 software and “LVS-7500 External System Operations Manual”) “LVS-7500 External System Installation and Quick Start Guide” (this document) LVS-7500 External System Readhead (5.4”/137 mm) or (8.5”/216 mm) Calibration Card (NIST Traceable) Base Plate Mounting Bracket with attached Internal Rewind Bar Docking Plate USB Cable 2.0 Certified (6 feet) (1.8 m) Power Supply (5-Volt).
Requires localized power cord for shipments outside North America AC Line Cord (for North American customers only) Stop Motion Interface Unit (or Light Tower Interface Unit if purchased by customer) 5/32” Allen Key Optional Items Light Tower Interface Unit. Replaces Stop Motion Unit. Provides color-coded warning lights to operator. Motor-driven take up nip roll (designed for fan-fold) Table-top label rewinder (winds up labels into a roll as they come out of a printer). Two available options:
o 1" to 4" (25.4 mm to 101.6 mm) Adjustable Core Holder o 8.6" (220 mm) wide "Quick-Chuck" and two label Flanges Customer-Supplied Items Two screws (8-32 or M4) for Stop Motion Unit mounting Two screws (8-32 or M4) for Light Tower Interface Unit mounting (if purchased) Thermal Printer (if interfacing the LVS-7500 External System to the printer for stop motion capabilities, refer to the “Stop Motion Printer Interface Requirements” section below for important printer requirements) Computer (see “Minimum Computer Requirements” below) Internal or external rewind is required to properly feed the labels for inspection.
Lack of a rewind will remove any responsibility from Omron Microscan . Mains power supply cable (for customers outside United States; this cable connects the power supply box to the wall power outlet) Minimum Computer Requirements Intel® Core™ 2 Duo Processor or equivalent (Intel® Core™ 2 Quad is preferred) 2 GB RAM (4 GB is preferred) 80 GB Hard Drive (500 GB preferred) LVS-7500 External System Installation and Quick Start Guide Page 5 of 45