Manual - BMV-712 Smart 2.5. Accessories These optional parts might be needed depending on your setup: Temperature sensor for BMV - to measure the battery temperature. GX Device, such as a Cerbo GX - for system and/or remote monitoring. VE.Direct cable - to connect the battery monitor to a GX device. Wall mount enclosure for BMV or MPPT Control - use in case panel mounting of the battery monitor head unit is not possible. VE.Direct to USB interface - to connect to the battery monitor via USB to a GX device or to the VictronConnect app. Wall mount enclosure for BMV and Color Control GX - use to wall mount the battery monitor head unit together with a Color Control GX in the same enclosure.
RJ12 UTP cable - use in case the supplied 10m (32ft) RJ12 cable (the cable between the shunt and the head unit) is too long or too short. These cables are available in a variety of lengths of 30cm up to 30 meters (1ft up to 98ft). Page 3 Introduction