VLT ® 2000 Series Factory settings and service Setup 1 Setup 2 409 RELAY OUT 01 X X UNIT READY UNT RDY CRTL ENABLEDnoWR RUNNING RUNNING noWR RNinRGE noWR RUN@REF noWR ALARM ALARMorWARN CURRENT LIM. OUT FRQ RGE OUT CURR RGE REVERSING 411 ANALOGUE REF TYPE LINEAR PROP W/MIN 412 INPUT #53 NO OPERATION X X 0-10 VDC 10-0 VDC Setup 1 Setup 2 509 SETUP SELECT DIGITAL BUS LOGICAL AND X LOGICAL OR 510 SPEED SELECT DIGITAL BUS LOGICAL AND X LOGICAL OR 511 BUS JOG 1 HZ 514 BUS BIT 4 X Q STOP D.C. BRAKE 516 BUS REFERENCE % 517 STORE DATA X X OFF ON 606 TOTAL OP HRS. 607 RUNNING HRS. 608 NO. POWERUPS 609 NO. OVERTEMPS 610 NO.
OVERVOLTS 413 INPUT #60 NO OPERATION X X 0-20 mA 4-20 mA 20-0 mA 20-4 mA 500 ADDRESS X 01 501 BAUD RATE 300 600 X 1200 502 DATA READ-OUT 503 COASTING DIGITAL BUS LOGICAL AND X LOGICAL OR 504 Q STOP DIGITAL BUS LOGICAL AND X LOGICAL OR 505 D.C. BRAKE DIGITAL BUS LOGICAL AND X LOGICAL OR 506 START DIGITAL BUS LOGICAL AND X LOGICAL OR 507 DIRECTION X DIGITAL BUS LOGICAL AND LOGICAL OR 508 RESET DIGITAL BUS LOGICAL AND X LOGICAL OR X = factory settings 104 MG.20.B6.02 – VLT is a registered Danfoss trademark