Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 101.21 Drawing notes. Drawing notes are used to provide information required to clarify the requirements for the item delineated. They may apply to a portion of the drawing or to the entire drawing, providing additional treatment, finish, protection, or other considerations. The notes area of a drawing shall be identified with the heading “NOTES”. 101.21.1 Languagee style. Notes shall be short, concise statements, using the simplest words and phrases for conveying the intended meaning.
Notes shall not include contractual requirements such as statements of costs, time and place of delivery, methods of payment, requirements for submission, approval or distribution of data, reports or plans. 101.21.2 Commonly used words and phasees. Certain words and phrases are frequently used on a drawing. The following rules shall be applied: a. Reference documents shall be cited as follows: (1) “...pe”...” (2) “...conforrning to...” (3) “... as specified in...” (4) “... in accordance with... ” or “... IAW...” b. “Unless otherwise specified” shun be used to indicate the generally applied requirements.
This phrase shall come at the beginning of the note or denoted at the head of the NOTES column. This phrase shall be used only when it is possible to clarify its meaning by providing a reference to another document, or requirement on the drawing, that clearly specifies the exception(s). 101.21.3 Use of “shall”. “will”. “should” and “may”. a. “Shall”. “Shall”, the emphatic form of the verb, shall be used whenever a requirement is intended to express a provision that is contractually binding. b. “Will”. “Will” may be used to express a declaration of purpose on the part of the Design Activity. It may be necessary to use “will” in cases when simple futurity is required. c. “Should” and “may”.
“Should” and “may” are used when it is necessary to express non-mandatory provisions. 100-9 Supersedes page 100-9 of 30 March 1992