Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 CHAPTER 600 REVISION OF ENGINEERING DRAWINGS 600 General. This chapter covers methods for revising engineering drawings and for identifying and recording revisions on original drawings. 601 Revision methods. Revisitions shall be made by erasure, crossing out, addition of information or by redrawing. 601.1 Change in dimensions. In general, any change in a dimension of a part should also be made to scale on the affected portion of the delineation. However. for manually maintained drawings, it is permissible to leave the delineation unchanged when the new proportion of the part is not noticetibly different from the original one.
If change to scale is not made, the practice outlined in ANSI Y 14.5M (for out-of-scale dimensions) shall be followed, If the drawing is redrawm, delineation shall be made to scale. Where the product definition is on an interactive computer graphics system the scale of the feature and dimension shall be I I 600-1 Superedes page 600-11 of 30 September 1991