MIL-STD-100E — MIL-STD-100E Notice 2: Engineering Drawing Practices PDF Download

Downloaded from https://www.everyspec.com MIL-STD-100E NOTICE 2 602.7 Required revisions. Any change to a drawing or associated list, except as noted in 602.7.1 and 605, requires advancing the revision level. When security classification is changed on a drawing, this will constitute a revision to the drawing. However, addition of CAGE Code (see 401) or initial inclusion of Distribution Statement (see 504 and Appendix E) may be accomplished concurrent with needed drawing revision but need not be described in the revisitions block or revisition authorization documents.

Subsequent changes to an indicated Distribution Statement shall require a change in the drawing revision level and an entry in the revision block or described in a revision authorization document. 603. Recording revisions on drawing level advance. A Distribution Statement and delivery contract numbers (see 504 and Appendix E) may be added to copies of contract~~r’s drawings upon release for delivery to the Government without revision action. 603. Recording revisions on drawing. 603.1 Revision block. Unless other-wise specified, revisions block format shall conform to ANSI Y14.1.

Each revision shall be recorded in the revisions block in accordancc with Figures 600-”1, 600-2,” and the following: 603.1.1 Letter. The identifying letter pertaining to the particular revision being recorded shun be entered in the “REV” column. 603.1.2 Description. A brief description of the change (see also) 602.6), or reference to the identity of the revision authorization document describing the charge, shall be entered in the description column. 603.1.3 Approval. The date of revision approval shall be entered in the “DATE” column, and signature or name entered in the “APPROVED” column. See 101.23. 603.1.4 Zoning.

When changes are recorded by zoning, the zone in which each change is made shall be entered in the “ZONE” column on the same line as the description of change. When the “ZONE” column is too small to identify all zones revised, the zones may be defined in the “DESCRIPTION” column and cross referenced to the zone column by symbol. 600-5 Supersedes page 600-5 of 30 September 1991