Downloaded from https://www.everyspec.com MIL-STD-1311D f. RF drive level to be applied, in terms of anode current, power output, or other as applicable. g. The rf test frequency range used shall be specified on the TSS. h. Minimum or maximum time to be held under the specified test conditions, if applicable. i. Test limit(s) for power output, and if applicable, the signal to IM distortion ratio. j. No negative feedback shall be used except the stage may be neutralized if required for stable operation. If neutralized, it shall be adjusted with no anode current flowing and no adjustments are permitted thereafter. 3. Procedures. a.
The TUT shall be set to operate under the specified idling conditions. Ibo shall be stable before proceeding with further testing. b. The noise rf drive signal, which meets the requirements detailed in 1.1 and figure 2206-1, is applied and set as specified with the notch-out. c. Power output (useful) is measured in accordance with figure 2206-3, note 6. d. Insert notch-in signal source and readjust drive level for power output measured in c above. e. Signal to IM distortion ratio is determined by comparing the relative noise power with the notch into the signal with the notch-out (at same power output).
This may be done with a selective voltmeter (see figure 2206-2) or by any other means which provides an accurate measurement of the ratio. FIGURE 2206-1. Characteristics of signal source (notch in case). METHOD 2206 2206-2 19 April 1968