Downloaded from https://www.everyspec.com MIL-STD-1311D METHOD 4225 RESIDUAL FM (Reflex klystrons) 1. Purpose. To describe a method for determining the magnitude of the residual FM deviations in the rf output frequency. 2. Definition. Residual FM is the background frequency modulation of the rf output which is contributed by the TUT and is not due to intentional modulation from an applied signal, or unwanted modulation contributed by the power supplies. 3. Equipment. 3.1 Power supplies to provide normal operating voltages and currents. 3.2 AC heater supply as specified on the TSS. 3.3 Equipment to monitor the rf output, as shown in figure 4225-1. FIGURE 4225-1.
Equipment for measuring residual FM. 4. Procedure. The residual FM due to the tube alone, is usually so small that conventional display devices, such as video spectrum analyzers, wave analyzers, microwave oscilloscopes, etc., are not calibrated accurately enough to measure the FM deviation values of interest. This method uses the TUT, along with the other equipment shown in figure 4225-1, to calibrate the output display device prior to reading the total residual FM level. 4.1 Calibration. 4.1.1 Use the audio oscillator to modulate the reflector electrode voltage of the TUT, and use the spectrum analyzer to observe the production of sidebands in the rf output.
METHOD 4225 4225-1 13 September 1972