Downloaded from https://www.everyspec.com MIL-STD-1311D 4.1.2 Vary the frequency and/or the output voltage of the audio oscillator until the spectrum analyzer display shows that the fundamental (carrier) frequency has been reduced to its minimum value. (Theoretically, the output power at the fundamental frequency of a frequency modulated source, follows the form of a Bessel function of the first order and the first kind. Such a Bessel function has its first zero (minimum) at 2.405. From this the modulation sensitivity (Ms) of the TUT in kilohertz per volt is given by: Where: Fm = frequency of the modulating signal (audio oscillator) in kilohertz.
Vs = voltage of the modulating signal from the audio oscillator. 4.1.3 Calibrate the video amplifier display device, using the known modulating signal frequency and amplitude, along with the measured modulation sensitivity of the TUT. 4.2 Measurement. Remove the reflector electrode modulation and record the maximum deflection of the display device. Convert the maximum deflection to residual FM using the calibrations previously derived, this shall not exceed the maximum limit as specified in the TSS. 5. Precautions. 5.1 The output frequency and modulating voltage supplied by the audio oscillator shall be known with whatever accuracy is required of the measurements.
5.2 The calibration level shall be sufficiently larger (at least four times larger) than the FM being measured to avoid erroneous calibrations. 5.3 The video bandwidth shall be wide enough to include all components of interest, or as specified on the TSS. (100 kHz is a typical video bandwidth.) 5.4 The beam and reflector power supplies shall be relatively free from hum and noise, or any inherent modulation from the TUT will be hidden. ) ( 7.1 ) ( 414 .1 405 .2 ) ( 405 .2 rms Vs Fm rms Vs Fm peak Vs Fm Ms = = = METHOD 4225 4225-2 13 September 1972