Downloaded from https://www.everyspec.com MIL-STD-1311D On figure 4231-1, controlling voltage intervals B and C show regions where hysteresis exists and A represents the voltage required to sweep through the full oscillating mode. The ratio of A C B + represents the percentage of the mode where hysteresis exists. (Some tubes may show hysteresis at only one side of the mode.) 5.2 Hysteresis (2). The ratio of the highest power level at which hysteresis occurs to the maximum power level shall be within the limit(s) specified. Suitable methods shall be used to calibrate the crystal response in terms of relative power level. FIGURE 4231-2. Hysteresis (2).
On figure 4321-2, the maximum output power for the mode is represented by A, and B represents the highest output power level at which hysteresis is observed. A maximum limit on the ratio A B is normally specified as a percentage. METHOD 4231A 4231-2 25 March 1970