Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D 5.2 Procedure. Using the circuit shown on figure 4250-5, the attenuator is adjusted such that the same indication is obtained at the receiver with the switch in either of positions 1 or 2. The power from the signal generator (Pm), which is at the same frequency as that of the unknown, is then measured. The unknown power level is then determined from the following relationship: Where: P = unknown power level to be determined in dBm. Pm = power actually measured in dBm. A = amount of attenuation in dB. k = coupling coefficient of couple in dB. NOTE:

If the coupling coefficient k is 20 dB or higher, the following simplified expression may be used with negligible error: + = 1 10 log log 10 k anti A Pm P P = Pm - A + k 6. Pulse duty factor method of peak power measurement. 6.1 Procedure. The average power is measured by either test A, B, or C as appropriate. The peak power is then determined from the following relationship: Where: Pk = peak power in watts. Pa = average power in watts. Du = duty cycle (pulse width times repetition rate, pulse width to be taken at 50 percent power points of the rf pulse.) 7. Notch wattmeter method. The notch wattmeter method is suited only for pulse power measurements.

In this method, power from a signal generator shall be combined in a directional coupler with power from the device under test. The signal generator shall be pulsed off for the pulse length of the device under test. It is important that the blank out time be negligibly small. Using the oscilloscope display the power level from the signal generator shall be adjusted to that of the device under test, as shown on 4250- 6. The combined output shall be fed to a bolometer and the power shall be measured with a power bridge. The power thus determined is the peak power of the device under test. Du Pa Pk = FIGURE 4250-6 Notch wattmeter oscilloscope display. METHOD 4250A 4250-4 25 March 1970