Downloaded from https://www.everyspec.com MIL-STD-1311D SATURATED RF POWER OUTPUT 1. Purpose. To measure saturated rf power output. (Saturated rf power output is defined as the maximum fundamental rf power output obtained when the only variable is the rf drive power.) 2. Equipment. The output power measurement test circuit indicated in method 4250 shall be used. 3. Procedure. The tube shall be operated at the voltages, frequencies, and conditions specified on the TSS. The rf drive power shall be increased until maximum power output is obtained. As the rf drive is increased, it is possible that a second peak of output power will be observed.
Only the first peak shall be used (see figure 4254-1), however. The second peak may be either lower or higher than the first. 4. Precautions. a. Harmonic filtering should be used. b. Rf drive power should not be applied in excess of that specified by the manufacturer. METHOD 4254 NOTE: Use first peak only. FIGURE 4254-1. Power output peaks. METHOD 4254 4254-1 18 August 1970