Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D 3.2 Procedure. Amplitude modulation is defined on the basis of two powers: (a) and (b) illustrated on figure 4262-4. Power output (a) is defined as the maximum deviation of average tube-power output from that observed when the modulation stimulus is momentarily removed. Momentary removals of the stimulus shall be frequent enough to eliminate from the measurements the effects of long-term or permanent degradations or increases in power output. Power output (b) is defined as the maximum peak-to- peak modulation of the tube-power output during the time the modulation stimulus is applied.

During the test, two-power measurements are made, one for -power output (a) and one for -power output (b). The devices used shall be such that the readout information is directly proportional to tube-power output. The frequency response of the readout for -power (a) shall be restricted such that the effective response of the circuit items and readout device taken in combination is equal to that of a one- section low-pass RC filter with a time constant of 2 seconds.

The frequency response of the readout for -power (b) shall be such that tube output fluctuations from zero up to a frequency equal to three times the maximum modulation stimulus input frequency shall be presented without appreciable attenuation. FIGURE 4262-4. AM based on two -power measurements. 4. Method C (amplitude modulation based on one -power measurement. 4.1 Test circuit. Same as 4262-3. 4.2 Procedure. Illustrated on figure 4262-5, amplitude modulation is defined as the maximum instantaneous deviation of tube power output (due to modulation) from the tube output when the modulation stimulus is momentarily removed.

Momentary removals of modulation stimulus shall be frequent enough to eliminate from the measurements the effects of long-term or permanent degradations or increases in power output. FIGURE 4262-5. AM based on one -power measurement. METHOD 4262A 4262-3 28 March 1975