Downloaded from https://www.everyspec.com MIL-STD-1311D ION NOISE MODULATION METHOD 4264A (Microwave tubes) 1. Purpose. The purpose of this test is to measure ion noise modulation of a microwave tube. 2. Test circuit. FIGURE 4264-1. Ion noise modulation. 3. Procedure. The TUT is operated as specified on the TSS in the circuit shown on figure 4264-1. Observe the rf output of the TUT on a spectrum analyzer and measure the amplitude modulation side bands which are typically within 50 kHz to 10 MHz either side of the carrier. 4. Precautions. 4.1 The sweep speed of the spectrum analyzer shall be slow enough to achieve adequate dynamic range and resolution.
4.2 Spectrum analyzers have finite resolution. Therefore, it may not be possible to make measurements as close to the carrier as may be required by some TSS's. In these cases, more elaborate angular phase measurement equipment is required and it shall be specified on the TSS. METHOD 4264A 4264-1 25 March 1970