Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D METHOD 4278A PHASE (Microwave amplifiers) 1. Purpose. The purpose of this test is to measure the several phase parameters of microwave amplifiers. 2. Equipment. The block diagram (figure 4278-1) describes the relationships of the system components while the diagrams on figure 4278-2 and figure 4278-3 show optional equipment which might be utilized in a laboratory phase measuring system. When power and frequency measuring devices are used, they shall be located external to the phase sampling arms leading to the comparator. FIGURE 4278-1 Basic phase shift measuring circuit. 3. Theory.

Phase measurements in microwaves are usually derived from substitution methods. However, microwave devices which incorporate velocity modulation principles or slow-wave circuits cannot be replaced by an equal length of transmission line because the physical length of the device bears no relationship to its electrical length. Furthermore, the position of the electron beam near the circuit participates in the determination of that electrical length and thus may cause the phase length to vary with input conditions and driving power as well as driving frequency. This method describes the means for making phase measurements.

A long length of transmission line has a phase frequency characteristic which is a direct function of its electrical length, as given by: Where: c = velocity of light = length in electrical wavelengths f = frequency The insertion of this line produces a shift in phase of which any fractional part of 360 ° is capable of measurement but any integral multiples of 360 ° will be lost. However, the slope of the phase-frequency curve measured when the line is inserted at a point in a phase measuring circuit is: rees = φ deg c f )1( 360 ) 2 ( 360 c f = The slope of the frequency-phase characteristic at a given frequency can then be inserted into equation (1) to determine the electrical phase length.

METHOD 4278A 4278-1 25 March 1970