Department of Defense MIL-STD-1311D — MIL-STD-1311D Test Methods for Electron Tubes — DoD Standard Manual PDF

Downloaded from https://www.everyspec.com MIL-STD-1311D 5.1 To further illustrate, the following represents typical "runs" and "counts" information that might be obtained when jitter is sampled in an incremental cumulative distributional manner. In this example, the following assumptions are made: a. A total of 1,000 pulses are sampled during each jitter increment. b. The pulse repetition frequency equals 1,000 pps. c. The ripple frequency is 120 Hz. Increment Runs Count 1 2 3 4 5 6 7 0 80 170 176 172 85 0 500 0 (50% counts) (0% counts) (100% counts) 5.2 With cumulative "runs" and "counts" information available, the random pulse-pulse rms jitter may be computed in the following manner:

Step 1: In the region of 50 percent counts, determine the average value of the number of runs. This includes ripple count. (In the example, average number of runs - 176.) Step 2: Divide this number of step 1 by a number which is 25 percent of the total number sampled during a count interval, to determine a ratio of 1,000 sampled pulses of number x ripple with runs 25 . (In the example, this ratio is 176 ч (.25 x 1,000) or 176 ч 250 = 0.7) Step 3: Establish the ratio of ripple frequency to the pulse repetition frequency of the TUT. (In the example, this is 120 ч 1,000 or 0.12) Then determine on figure 4318-11 the point of intersection with the ratio obtained in step 2.

This will enable a value of N, the ratio of jitter random ripple of value peak to be determined by the example N = 1.6. Step 4: Using this value of N, determine a new upper limit for statistical σ on the probability versus N graph. (See figure 4318-12.) (In the example, new limit of σ = 82.5.) Step 5: Determine the value of σ m, ( σ measured), by measuring the jitter between 50 percent and the upper limit obtained from step 4 on a curve of percent counts versus jitter such as is illustrated on figure 4318-5 by σ m(2). METHOD 4318 4318-4 19 April 1968