Downloaded from https://www.everyspec.com MIL-STD-1311D IGNITOR NOISE RATIO METHOD 4460A (Gas-switching tubes) 1. Purpose. The purpose of this test is to measure the ratio of noise power output of the gas-switching tube with ignitor operating, to that of the tube without ignitor operating. 2. Equipment. The basic circuit shown on figure 4460-1, or its equivalent, may be used for this test. FIGURE 4460-1. Equipment layout for noise ratio measurement. 3. Procedure. With the noise source and the isolator in the circuit, the noise figure of the receiver is measured and recorded.
With the gas-switching tube and matched termination in the circuit and using the same convenient level of receiver output (as in step 1 on the output indicator), the ignitor is energized and the ignitor current is set to the magnitude stated in the TSS. The increase in noise level is nullified by increasing attenuation to yield the previous level at the output indicator, and the increase in attenuation is measured. 4. Formula. The noise ratio is computed from the pertinent formula as shown: a. Single-sideband receiver: NR = 1 + F(y-1) b. Double-sideband receiver:
2 )1 ( 1 + = y F NR Where F = Receiver noise figure (power ratio) y = IF attenuation (power ratio) required to counteract the ignitor noise power. METHOD 4460A 4460-1 25 March 1970