Downloaded from https://www.everyspec.com MIL-STD-1311D METHOD 4486 FIRING TIME (ATR and pre-TR tubes) 1. Purpose. The purpose of this test is to determine whether the tube fires within the time limit specified, under the specified operation conditions. 2. Equipment. FIGURE 4486-1. Equipment layout for firing time test. 3. Procedure. 3.1 ATR tubes and single pre-TR tubes. Set the equipment up as indicated on figure 4486-1, or an equivalent circuit, at the required power level, with the short circuit in place of the TUT. With the tube inserted in the test equipment, the time for the tube to fire, after the application of power, as indicated by an abrupt change on meter No.
2, shall be within the limit(s) specified. 3.2 Dual pre-TR tubes. The same procedure shall be used to test dual tubes in the equipment shown on figure 4486-2. FIGURE 4486-2. Equipment layout for firing time measurements. METHOD 4486 4486-1 19 April 1968