Downloaded from https://www.everyspec.com MIL-STD-1311D WRITING AND ERASING RESPONSE, DYNAMIC, ELECTRICAL OUTPUT METHOD 5418 (Cathode-ray charge storage tubes) 1. Purpose. The purpose of this test is to measure the dynamic writing and erasing response of an electrical output cathode-ray charge storage tube while writing at the specified scanning speed and while simultaneously erasing at the specified rate. This test method is intended primarily for dual-gun tubes used in radar display applications. 2. Definitions. a. Destructive reading is reading that partially or completely erases the information as it is being read. b.
Write saturation level is that output level beyond which no further increase in output is produced by further writing. 3. Equipment. `a. Unless otherwise specified in the TSS, the writing deflection system shall produce a raster of 100 equally-spaced lines from a linear sawtooth frame sweep with a 5-second duration at a 12-scan per minute repetition rate, and a linear sawtooth line sweep having an active period of 250 microseconds. The reading deflection system shall produce a television-type raster in the TUT with the reading line scan orthogonal to the writing line scan. b.
The output from the TUT shall be monitored on a CRT with raster scan synchronized to the reading raster, and on an oscilloscope with provisions for selecting the video output from any line of the reading raster. c. The output-signal amplifier shall be linear, compensated for the output impedance of the TUT, and have a frequency response that is flat within 1 dB between frequencies (f 1 ) and (f 2 ), to insure accurate reproduction of the output signal from the TUT. The low-frequency response shall be such that a pulse at the input of the amplifier, having a duration equal to the reading raster line-scan duration, will be reproduced at the output with no more than 5 percent droop.
f 1 = the read scan-line repetition line (Hz). f 2 = D J R MHz. Where: R is the anticipated limiting resolution of the TUT in WRSL/SSRD. J is the read scan-line length as a fraction of the SSRD. D is the active read scan-line duration in microseconds. SSRD is storage surface reference dimension as determined by method 5405. WRSL is written raster scan line. (d) When operating tubes in other than the destructive reading mode, an erase control circuit shall be provided to give a time-shared, gradual-fade erasing function. METHOD 5418 5418-1 12 December 1972