.- t.iIh5TD-810B 15 June.1967. Downloaded from https://www.everyspec.com MBTSOD 514.1 VIBR&TION 1. krDose. - The vibration test is pe?formed to determine if equipment is constmcted to withstand expected dynamic vibrational stresses EUIdto insurethat perfomnance degradationsor malfunctionswill not .be produced by the servicevibration erivironment.Tests specifiedherein are established for equipmentwhich may be used in a variety of military applications. 2. @paratus. - Vibrationequipment with required instrumentation. 3. General.
- Tne vibrationtest charts, tables 51b.1-I through 514.1-VII, provide a convenient means of summarizing test procedures to be specifiedin the equip- ment specificationor test plan according to various military applications. Each table title refers to the applicablecategory of the equipment to be tested. The tables are divided into two m.aJorsections. Section A, “Test procedure and time schedulechart,” specifies the tests to be imposed on the equipment and the test time schedule fcm each test. Section(s) B(C),’’Curveselection chart,” specifiesthe vibration test curves applicable tO that particuk equipment category and application.
Guidance for select- ion of the vibration test for an item is as follows: (a) Determine equipment catego~ (or categories)in accordancewith 3.1, (b) Proceed to the applicable table correspondingto equipment category through (h) or 4,17 for category (i) equipment. Select a procedure the table based on the following equipment mounting configuration: (a) from ,/ (l) Without vibration isoktors (2) With vibration isolators (3) Tied down (4) Loose (c) For all proceduresexcept IX, XI, and XIII, select the applicabletest Level curve(s) from tables 51b.1-1 through 514.l-VII in accordancewith 3.3 based on:
(1) Listed selection criteria (2) Detailed knowledge”of the specific equipment environment 514.1-1 MM!iOD 514.1 ..., 20 October 1969 . .. ,.. , (: