MIL-STD MIL-STD-810B Method 513.1 / 514.1 — MIL-STD-810B Method 513.1 Acceleration & 514.1 Vibration Test Standard PDF

~;... -, > ,. , . ., . . .. . . ~ ..... . . . . , ,- + . , ? ., : .- +: .. : ~.:. @;.r>. .. J:, .:.. ...$. + ,,- . ..,,.. ...,,’ - ,-MIL-SD.81OB :._ii’ .-s:;. .~:-:~:”:::c.‘~.~”‘. ~+.-.,,+. .. .. .15Juqe@967.A: ~,,. .: ., .. ,,.,,,, > Downloaded from https://www.everyspec.com 3.1 ~Equipment category.- For purposes of this test method, kquipent is categorized according to the vehicle In which it will be installed or transportedas f~: ... CATEOORY -, :. (a) Equipment installed and figurej514.1-1) in airplanes and helicopters (see”@e’51~. 1-I ..

- (b) Equipment installed 514.l-II end figure in airplanes,excluding helicopters (see table 51b.1-2) Equipment installed 5U.1-3) in helicopters (see table 514.1-111 and figure (c) (d) Equipment instalied figure 514.1-4) in air launched missiles (see table 514.l-IV end ,,.. . :,. .

(e) Equipment installed figure 51b.1-5) in ground launched missiles (see table 51b.1-V and (f) Equipment installed >14.1-6) in ground vehicles (see table 514.l-VI and f’igme (g) Equipmenttransported by common carrier, land or air (see table 51h.1-VII and figure 51k.1-7) (h) Ground equipment,excluding category f (for transportationtest, see category g) //-,., , Shipboard and eunpbibiousequipment or when a ship ie the common carrier (i) (see L.17) 3.2 Applicable tests. . For any given equipment category, all tests listed beside the selected procedure for the applicable equipment KmInting configurationin tables 51b.1-1 through 514.1-WI shall be performed unless otherwise specified.

For example, refem-~ b table 514:1-Iv section A, for testing equipment category (d) when Fmcedure III is selected, there are four parts with four different test levels Indicated by the test curves. Tests indicatedby in all four parts shall be performed to evaluate equipment installed in an air launched missile for both the captive and flight phase. . ,. . . . . 3.3 Selection of test curves. - A curve shtii‘be.se~ec~e~~iin~tables 51h.1-1 ttio~h 51k.1-VII or by ,pakinga detailed analysis of the ,expectedvibretion environ- ment within the pdiculu vehicle involved.

A primary considerate ion is the equipment location with respect to predominant vibration sources such as high intensIty noise of jet and rocket exhausts, &o@mic excitation includingatmosphericwind and turbu- lence, and unbalance of rotating parts. Additional factors to be considered shall in- clude attenuation,or amplificationand filtering by structuralmembers. Guidance for ;METROD 5,14.1 514.1-2 “.20October 1969 ... ,... ,.. ,,. .