MIL-STD MIL-STD-810B Method 513.1 / 514.1 — MIL-STD-810B Method 513.1 Acceleration & 514.1 Vibration Test Standard PDF

,)> MIIAYTD-81OB 15 June 1967 ,,.. . selecting vibration curves with respect to .squipmentlocation or application is given in section(s)B(C) of tables >lk.1.I through 51b.l-VII. Applicable test curves for each equipment category are shown on figures 514.1-1 through 514.1-7. In some instances, several curves are shown for one equipment category. When the ,equipment,due to its ,. aPPlicati~, may be subjectedto more than one level of particular type of vibration, the curve representingthe most severe level shall be selected.

Downloaded from https://www.everyspec.com 3.b Examples of procedure selection.- The equipment specificatia or test plm shall identify which tests are to be imposed on the equipment by specifying the appli- cable procedure and test curve(s) when applicable. Tables 51h.1-1’through 51h.1-VIIand figures 51~.1-1 through 514,1-7 are arrangedto accommodatethis identification. 3.4.1 Example No, 1. . Select the test conditionsfor equipment to be used in the following application. Category: Equipment installed in airplane (Jet engine at rear of fuselage) Equipment location: Forward half of fuselage Equipment mounting: On vibration isolated panel . .

Referring to table 51b.1-11, the above identificationspecifiesthe following test conditions: Procedure I Part 1 (curve J) ,/- Part 2 (curveAR) Part 1 specifies a resonance search, resonance dwell and sinusoidal vibration cycling to the level of curve J from figure 514.1-2within the time schedule specified for part 1 on table 514.1-11. Next, with vibration isolatorsremoved in accordancewith note 2, part 2 is performed the same as part 1 but to the test level of curve AR from figure 51b.1-2 within the time schedule specified for part 2 from table 514.l-II. 3.4.2 Sxwnple No. 2. - Select the test conditions for equipment to be used in the following application: Category:

Equipment installed in air launchedmissile (missile thrust/ ! weight ratio 15/1 and carried on airplane wing of Jet airplanewith wing mounted engines). Equipment location: Equipment in missile booster section Equipment mounting: Without vibration isolators (hard mounted) 514.1-3 MSTSOD 514.1 20 October 1969 ,.. ( .