Downloaded from https://www.everyspec.com ~ MIL-STD-81OC 3.3.4 Application of gunfire prediction surfaces. Determine the value of D (see 3.3.3), establish the values of G~s and G:= (see 3.3.2); and using the locator grid at the top of figures 519.2-2 and 3, respectively, find the intersectionpoints of f/f. (f/fo.) and D. From these points drop down vertically until the prediction surface is intersected. Measure the verti- cal distance with a ruler or dividers. Transfer this distance to the dB scale keeping the grid intercept in the zero dB plane. This distance, in dB, represents the magnitude of Gs or Gr referenced down from G~~ or G~r (determinedin 3.3.2).
The equational form for this procedure appears as the following: 10 loglo Gs = dBs (6) ~s 10 log10 Gr = dBr (7) ~ or G, = a value of g 2. s,me on the sinusoidal prediction surface at a given value of D and f/f (see figure 519.2-2) 0 Gr = a value of g2/Hz on the high frequency random prediction surface at a given value of D and f/f dBs = the value of Gs, in dB, referenced to G=0s dBr = the value of Gr, in dB, referenced to G~r 3.3.4.1 Determination of the low frequency random spectrum. Reference to figure 519.2-4 shows that the maximum value of the low frequency random case (Gr ~ax) occurs at f/f. = 2.0 and has the same value for the high frequency spectrum at f/fo.= 0.7.
Since Gr max has been determined for tie high frequency random (3.3.4), transfer this value to figure 519.2-4 and plot (see 6. for an example). METHOD 519.2 519.2-6