U.S. Department of Defense MIL-STD-810C — MIL-STD-810C Environmental Test Methods Standard — PDF Manual Download

Downloaded from https://www.everyspec.com I MIL-STD-81OC 4 5. TEST PROCEDURES 5.1 Procedure 1, Sine superimposed on random vibration. The test item shall be subjected to vibration along each mutually perpendicular axis. The excitation shall consist of four sinusoids superimposed over a rsndom vibration background. The sinusoids shall be at frequencies representing the basic gunfire rate, and the second, third and fourth orders (f~, f2, fs, fl). Synchronous1y, the frequencies shal1 be swept oveT a bandwidth equal to *.2fl, t.2f2, t.2f3, *.2f1 beginning at the low frequency end and ending at the high frequency limit.

The sweep time for the combination sine sweep and random vibration shall be 15 minutes per sxis. The instan- taneous peaks of the random vibration may be limited to 2.5 times the rms spectral acceleration level. The test envelope tolerances shall be as indicated in table 519.2-111 and figures 519.2-20, SIg,2-21 and 519.2-22. 5.2 Procedure II,”single direction test. If the equipment item is mounted with the base peripherally attached onto and in the plane of the aircraft skin, then the test direction may be restricted to the direction normal to the aircraft skin (see figure 519.2-23). The total test time in this case shall be 30 minutes. 5.3 Procedure III, alternate test.

For 1arge equipment located near the gun muzzle, the overall test levels may exceed the force capabilities of al1 but the largest shaker systems. For such cases the sin~soidals may be separated from the random vibration and each test run independently -- each test shall run for 15 minutes per axis. ~ 5.4 Procedure IV, alternate test (Pulse method). If no equipment is avail- 1 able to provide a test in accordance with Procedure I then a sweptrepetitive pulse technique may be used as an alternate method; provided that the pulse method is in compliance with the following requirements. 5.4.1 Spectral content.

The generated spectrum shal1 consist of discrete acceleration magnitudes whose frequencies (f) correspond to the expression f=nf~: where fl is the basic gunfire rate and n = 1, 2, 3 ...k. The last integer (k) is that value of n for which nfl is nearest to the maximum test frequency, 2 RHz. 5.4.2 Spectral magnitude and shape. The pulse test spectrum shall be defined by an envelope that outlines the discrete magnitudes of the low frequency sinusoids (formerlyderived for Procedure 1) and extends to conriectwith the envelop of the converted high frequency random spectrum as derived in 3.3.6. Note that the low frequency random spectrum of Procedure I is not used. ~ 519.2-12 MSTHOD 519.2 4 ..:...,