Downloaded from https://www.everyspec.com MIL-STD-81OC Sinusoidal Spectrum G;~ = 1910 g* f. = 2S0 Hz f/~ 0 f dB (re. G: ~ax) +dBH = dBY~ g*/grms 2.0 500 -14.7 0.0 -13.0 -13.0 3.24/1.80 1.6 400 -15.2 -0.5 -11.8 -12.3 3.80/1.95 1.2 300 -16.8 -2.1 -10.0 -12.1 4.00/2.00 1.0 250 -18.6 -3.9 - 8.6 -12.5 3.65/1.91 0.8 200 -21.1 -6.4 - 6.8 -13.2 3.10/1.76 0.6 150 -23.0 -8.3 - 3.7 -12.0 4.00/2.00 0.4 100 -24.0 -9.3 + 1.8 - 7.5 11.6/3.40 0.32 80 -24.4 -9.7 + 4.0 - 5.7 17.39/4.17 The transfer function dBH appears & a column that, in freqUenCY correspondence,is added to dBs. The details of this derivation now follow. From 3.4 note equations (15) and (16). Go to table 519.2-11, Cate- gory II(a).
The block, concerning a knowm fnl, requires that K (figure 519.2-18) be set at 2.0; independent of equipment weight. From figure 519.2-18 insert K = 2 as indicatedin thef/fn parameter. .Also insert fn~ = 45 Hz. This step establishes the low fr~quency scale. Note that each octave of frequency is divided into three bands. This scale is, therefore, 1/3 octave. To obtain the frequency in the upper adjacent 1/3 octave it is only necessary to multiply the preceding frequency by 1.26. Establish frequencies correspondingto the sinusoidal surface (Gs), previously developed. Measure dBH values (preferably with dividers) and enter in the column designated dBH.
In accordance with equation (15) add dBH to dB~ to obtain dBy ; the desired spectrum. Remember that dBYs is referenced to Gs ~ax whic?iis - 14.7 dB relative to G~s. ‘Ihus,Gsrnax”= (.03388)(1910G2) = 64.7 g2 = 8.04 grins. 519.2-23 METHOO 519.2