Grip the carrier disc by the recessed grips and lift out of the bowl. Turn the carrier disc over and carefully press out the insert from the underside (Fig. ). en The blade is sharp and can cause injury! Exercise particular caution when handling the attachments! Note shape and location of the insert when inserting it into the carrier disc. Take hold of carrier disc by the designated recessed grips only. Do not place fingers in the feed tube. Only use the pusher when adding more ingredients. Cleaning Base unit and tools Warning! Never immerse the base unit in liquids and do not clean in the dishwasher. Do not use a steam cleaner! Surfaces may be damaged.
Do not use abrasive cleaning agents. If processing e.g. red cabbage or carrots, the plastic parts will become discoloured by a red film which can be removed with a few drops of cooking oil. Pull out the mains plug! Wipe the base unit with a damp cloth and then wipe dry. The blender jug can be cleaned in the dishwasher. Clean the blender foot in the dishwasher or with a brush under running water. Dry the blender foot in an upright position (blender blade face up) so that any trapped water can run out. Whisk Warning! Never immerse the gear attachment in liquids and do not clean under flowing water or in the dishwasher. The whisk can be cleaned in the dishwasher.
Wipe the gear attachment with a damp cloth only. Multifunction accessory Warning! Never immerse the lid of the multifunction accessory in liquids and do not wash in the dish washer. Wipe lid with a damp cloth only or rinse briefly under running water. Bowl, universal blade, carrier discs and disc inserts are dishwasher-proof. Do not wedge plastic parts in the dishwasher as they could warp. Caution! The disc inserts must not be used for cutting very hard foods (Parmesan cheese, choco- late). The disc inserts are only partly suitable for processing fibrous foods (leek, celery, rhubarb). Fig. Place bowl on a smooth and clean work surface.
Insert the required insert into the carrier disc. Note the form and the location (Fig. -1)! Take hold of carrier disc by the recessed grips and insert into the bowl. Place lid on the bowl and turn all the way anti-clockwise. Place the base unit on the attachment and lock into position. Insert the mains plug. Set the required speed with the speed control. Hold base unit and multifunction accessory firmly and switch appliance on. Put ingredients to be cut or shredded through the feed tube. When adding contents which are to be sliced or shredded, apply only light pressure to the pusher. Warning!
Empty the bowl before it becomes so full that the cutting or grating contents reach the carrier disc. Release the On button after processing. After using the appliance: Remove mains plug. Press the release buttons and remove the base unit from the attachment. Turn lid clockwise and remove from the bowl. Robert Bosch Hausgerдte GmbH 15