Cleaning and servicing en Wait until the appliance stops. 7. Pull out the mains plug. ▶ Never touch the sharp blades and edges with bare hands. Emptying the bowl 1. Rotate the lid anticlockwise. → Fig. 21 Markings and must match up. 2. Remove the lid. → Fig. 22 3. Take hold of the disc holder by the shaft and take out of the housing with the cutting disc. → Fig. 23 4. Take hold of the cutting disc by the edge and remove. → Fig. 24 Tip: You can empty the bowl during processing without removing the con- tinuous feed shredder. 1. Set the rotary switch to . Wait until the appliance stops. 2. Press the release button and raise the swivel arm until it engages. → Fig. 17 3.
Turn the bowl clockwise and re- move. → Fig. 18 4. Empty the bowl. Tip: Clean all parts immediately after use so that residues do not dry on. Removing the continuous feed shredder Cleaning and servicing Cleaning and servicing WARNING Risk of injury! Improper use may cause injuries. ▶ Only attach and remove accessor- ies once the drive has stopped and the appliance has been un- plugged. To keep your accessory working effi- ciently for a long time, it is important to clean and maintain it carefully. Dishwasher-safe components Find out here which components can be put in the dishwasher. 1. Rotate the continuous feed shred- der anticlockwise until it releases. → Fig. 19 2.
Remove the continuous feed shredder from the base unit. → Fig. 20 ATTENTION! Some parts may be damaged if they are put in a dishwasher. ▶ Only put dishwasher-safe parts in the dishwasher. ▶ Only use programmes that do not heat the water above 60 °C. ▶ Do not wedge plastic parts in the dishwasher. Dismantling the continuous feed shredder WARNING Risk of cutting! The cutting discs have sharp blades and edges. ▶ Only take hold of the cutting discs by the edge. Dishwasher-safe: Ў Housing Ў Lid Ў Pusher Ў Disc holder 21