Basic operation en 1. Set up the base unit as described in the main operating instructions. 2. Press the release button and move Assembling the juicer attachment 1 Follow the illustrated instructions. → Fig. 10 - 14 the swivel arm down until it en- gages in the vertical position. → Fig. 3 a The swivel arm is fixed in posi- Assembling the Viennese whirl attachment 1 tion 3. 3. Rotate the base unit to the operat- Follow the illustrated instructions. → Fig. 15 - 18 ing position. → Fig. 4 Assembling the grater attachment 1 Follow the illustrated instructions. → Fig. 19 - 22 Inserting the seal ▶ Insert the seal into the housing and press in firmly. → Fig. 5 The recesses must match up ex- actly.
Fitting the attachment 1. Open the locking lever. → Fig. 23 2. Hold the prepared attachment hori- zontally and match up the ends of the agitator paddle with the drive. → Fig. 24 3. Push the attachment fully onto the Assembling the attachments Note: To use the special accessory, you need the parts of the meat min- cer, except for the knife and perfor- ated disc. drive. 4. Rotate the attachment anticlock- wise as far as possible. → Fig. 25 5. Close the locking lever. Assembling the meat mincer 1. Fit the worm gear into the housing → Fig. 26 6. Tighten the threaded ring clock- with the agitator paddle at the front. → Fig. 6 2. Fit the knife onto the worm gear wise. 7. Attach the filling tray.
→ Fig. 27 8. Place a suitable container under with the square projection at the front. → Fig. 7 3. Insert the required perforated disc the attachment. → Fig. 28 into the housing. → Fig. 8 Observe the recess on the perfor- ated disc. 4. Fit the threaded ring and tighten Basic operation Basic operation Basic operation You can find out everything you need to know about operating your ac- cessory here. clockwise slightly. → Fig. 9 1 Special accessory 19