omron — 2-3-2 Connecting by USB

2 Installing the NB Unit and Connecting Peripheral Devices 2-3 Connecting of NB-series with PC 2-3-2 Connecting by USB Use the USB transmission cable to connect the USB A-type port on PC side with the USB SLAVE B- type port on NB Unit. As to the USB connection, there are some preparations and restrictions that need to be done or heeded. Refer to the following content to ensure a correct connection. Take NB5Q/NB7W-TW01B as example: Connect the USB port at the PC side and the USB slave connector of the NB Unit. 2-3-2 Connecting by USB  USB driver for the NB-Designer A USB driver needs to be installed in the PC for the purpose of transmitting screen data through USB.

The USB driver should be installed at the first time when connecting the NB Unit to a PC. Please refer to 2-4 Installation of USB-Driver for NB in the NB-Designer Operation Manual for details on the USB driver. Precautions for Safe Use • Commercially available and the recommended USB HUBs are different from the general specifications of the NB Unit. The Unit may not function well in an environment subject to noise, static electricity. Therefore, when using a USB HUB, employ sufficient noise and static electricity insulation measures, or install it at a site free of noise or static electricity. • Do not connect a USB connector to any device that is not applicable.

• Before connecting a USB connector to a device, make sure that the device is free of damage. NB-series Programmable Terminals Setup Manual(V107) 2-9 2