omron — 2-4-3 Settings for each Unit

2 Installing the NB Unit and Connecting Peripheral Devices  Settings for the front-side DIP Switches To activate the settings of [PLC System Settings Area] (Data memory), set as follows according to the PLC: • For C200HX/HG/HE (-Z) and RS-232C of CQM1H For C200HX/HG/HE(-Z) For CQM1H Communication condition setting for the RS-232C port Set the DIP switch 5 to OFF, and activate the “settings” in PLC system settings. • For CPM2A Set the communication condition setting switch to [OFF] (downwards). • For CPM2C (Only the RS-232C port can be connected) Carry out settings according to the using conditions of the peripheral port and built-in RS-232C port.

• When connecting the PT to the built-in RS-232C port (connect the device that needs to perform communications other than that within the standard setting range) Set SW1 to OFF Set SW2 to ON • When connecting the PT to the built-in RS-232C port (connect a programming console to the peripheral port) Set SW1 to OFF Set SW2 to OFF 2-16 NB-series Programmable Terminals Setup Manual(V107)