omron — 2-4-3 Settings for each Unit

2 Installing the NB Unit and Connecting Peripheral Devices 2-4 Serial Communication Connection When connecting to a NX Series Serial Communication Board For NX1W-CIF01 (RS-232C) For NX1W-CIF11 (RS-422A/485 No-isolation) For NX1W-CIF12 (RS-422A/485 Isolation)  Setting for the CPU Unit Set the CPU Unit configuration below with peripheral tool (Sysmac Studio).  Configuration and Option Board Serial Communications Settings Configure these settings in the Option Board Settings Tab Page, which is displayed by selecting Option Board Settings under Configurations and Setup - Controller Setup . 2-4-3 Settings for each Unit Under Configuration , specify the models of the Option Boards to use.

Under Option Board Settings , configure the following settings: Serial communications mode Host Link (FINS) Unit No. 0 Baud rate Set this to match the setting on the NB-series Unit. Data length 7 bits Parity Even Stop bit 2 bits NB-series Programmable Terminals Setup Manual(V107) 2-25 2 Item Set value