omron — 2-4-3 Settings for each Unit

2 Installing the NB Unit and Connecting Peripheral Devices  Memory Settings for CJ-series Units Specify the memory used for CJ-series Units in the Memory Settings for CJ-series Units Tab Page, which is displayed by selecting Memory Settings under Configurations and Setup - Controller Setup . Set the area type and the number of words of memory enough to include the memory that will be used for the screen data to create. Precautions for Correct Use Precautions for Correct Use Create screen data to avoid using the EM area because the NX1P2 CPU Unit does not support the EM area type.

 Settings on the NX1W-CIF11/CIF12 Option Board The CPU Unit requires an NX1W-CIF11 or NX1W-CIF12 Option Board for connection with external devices via RS-422A. The table below shows the settings of the operation setting DIP switches on the back of the Option Board. *1 Turn this OFF if the NX1W-CIF11/CIF12 is not the terminating device. For details about the [Option Board Settings], refer to NX-series NX1P2 CPU Unit Built-in IO and Option Board User’s Manual (W579). 2-26 NB-series Programmable Terminals Setup Manual(V107) CIF11 CIF12 Setting Setting description SW No. SW No.

SW1 1 SW1 1 ON With terminating resistance (*1) 2 2 OFF Four-wire type 3 3 OFF Four-wire type 4 4 OFF (Not used) 5 SW2 1 OFF Without RS control for receive data (Always receive data) 6 2 OFF Without RS control for send data (Always send data)